Electric Start Ready To Run Gas Truck with Traxxas Pro .15 (2.5cc) Engine!
Just add Fuel and "AA" Batteries!
This is the glow powered, radio controlled Ready-To-Run
Traxxas Nitro Stampede 1/10 scale Monster Truck.
FEATURES: Chassis: 6061 T-6 aluminum anodized blue
Radio: Traxxas TQ 27MHz AM with high torque steering servo,
trim and servo reverse, transmitter does not have charge jack
Engine: Traxxas Pro .15 (2.5cc) with two-needle rotary carb, glow
plug and EZ-Start electric starter with battery and charger
Exhaust: Composite construction rear tuned pipe with two outlets
Drive: Rear wheel
Body: Pre-painted, pre-cut polycarbonate body with decals applied
Ball Bearings: Full set included, rubber sealed
Shocks: Four Ultra shocks oil-filled w/ powder coated White springs
Slipper Clutch: Adjustable
Suspension: 4-wheel independent
Transmission: Magnum 375 with 32 pitch gears and ball bearings
Differential: Planetary gear with steel internal gears
Spur Gear: 66-tooth composite construction
Clutch Bell: 18 tooth steel
Fuel Tank: 2.5oz (75cc) with flip-top lid and primer bulb
Brake: Composite disc type
Tires: Revo spec Talon 2.8" (71mm) inner diameter 4.75" (121mm) outer
diameter with foam inserts
Wheels: Chrome finish 5-spoke Traxxas All Star 2.8" (71mm) diameter,
2.0" (51mm) wide
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
INCLUDES: Assembled Nitro Stampede with Pro .15 (2.5cc) engine and glow plug,
EZ-Start electric starter, painted body with decals, TQ pistol grip
radio two servos, instruction sheet, 66-tooth spur gear, 18-tooth
clutch bell, battery and charger for EZ-Start
REQUIRES: "AA" Batteries: 12 (8 for transmitter and 4 for receiver)
Fuel: Car fuel with 10-15% nitromethane content
Misc. Items: Fuel bottle and building and track equipment
SPECS: Length: 17" (432mm)
Front and Rear Track: 12.75" (324mm)
Weight: 5.2lb (2.35kg)
Height: 9.5" (241mm)
Wheelbase: 10.75" (273mm)
Ground Clearance: 4" (102mm)
Gear Ratio: 3.75:1 (internal)
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
4 5x11mm Front Wheels 2 DTXC1547
4 5x11mm Rear Wheels 2 DTXC1547
6 5x11mm Transmission 3 DTXC1547
2 5x11mm Clutch Bell 1 DTXC1547
REPLACING EZ STARTER WITH STANDARD RECOIL STARTER
To convert the EZ starting to a standard pull starter, purchase
part numbers TRAG5170, TRAP5211 one-way bearing, four 3x8mm machine
screws, take out the three bolts on the EZ-Starter clip the wires
on the EZ-Starter, and install recoil pullstarter.